How To Repair A Samsung S6 Edge Screen

Repair guide : Display Assembly Samsung Galaxy S6 Border

Level : Very difficult Time : sixty min Author : Alexandre

1605 people have done this repair successfully ! Why not yous?

This guide is for disassembling the display assembly on the Galaxy S6 Edge
Symptoms : broken or damaged display assembly

Some advice before yous start

Repair - Repair guide: Display Assembly Samsung Galaxy S6 Edge

Step 1

Before replacing the display associates of your Galaxy S6 Border, you accept to turn it off for safety reasons.

To do so, press the ability push for a few seconds and click on "Plough off".

Footstep 2

The rear glass of your Galaxy S6 Edge is glued to its frame. Yous take to soften the glue with a hair dryer. Rut up the top and bottom part of the rear panel for 20 to 30 seconds top.

Don't heat over 30 seconds the rear glass of your S6. Y'all could damage the NFC cable / built-in wireless charging.

Attach a suction cup to the lower half of the rear glass console and while pulling information technology, insert an opening selection on the right side of the rear drinking glass.

Then slide the opening option toward the top function of the S6 Edge.

Step 3

Continue by gently sliding the opening pick along the iv sides of the Galaxy S6 Edge.

Step 4

Then grasp the rear glass softly lift information technology to open it, as shown on pictures i and ii of this step.

Proceed to fully remove the rear glass.

The rear panel of your Samsung Galaxy S6 Edge is at present removed.

Pace 5

With a cruciform screwdriver, remove the 11 screws circled in red that secure the midframe.

Then utilize a nylon spudger to uncover the white adhesive tape roofing the two other cruciform screws .

Then remove the 2 screws.

Step vi

The midframe will now easily separate from the rest of the telephone.

Gently pull it back and remove it.

The midframe of your Samsung Galaxy S6 Edge is now removed.

Step seven

Use the spudger'south tip to disconnect the Bluetooth and GSM interconnect cable connectors, near the logic board.

Pace 8

Then disconnect the LCD screen and the home push cablevision connector.

Footstep nine

All the same with the nylon spudger, disconnect the phone's front camera.

Remove it with a pair of tweezers.

Step ten

Disconnect the earpiece speaker / proximity - light sensor every bit well as the battery.

Step 11

Gently elevator the logic board.

Flip it over as shown on pictures 3 and iv.

Step 12

With the nylon spudger, gently remove the battery without damaging it.

Step xiii

Grab and remove the bombardment.

Step 14

Utilise the nylon spudger and disconnect the dock connector cablevision.

The logic lath of your Samsung Galaxy S6 Border is now disassembled.

Stride fifteen

Employ the spudger's tip and gently pry the proximity and calorie-free sensor bracket.

Take hold of it with a pair of tweezers.

Step xvi

Notwithstanding using the tweezers, grab the earpiece speaker / proximity - light sensor and remove it.

The earpiece speaker / proximity - light sensor of your Samsung Galaxy S6 Edge is now disassembled.

Step 17

With the spudger'southward tip, gently peel off the vibrator and remove it.

The vibrator of your Galaxy S6 Edge is at present disassembled.

Step 18

Keep using the nylon spudger, disconnect the logic board and remove it.

The logic board of your Galaxy S6 Border is now disassembled.

Step nineteen

With a cruciform screwdriver, remove the 2 screws circled in cherry-red that secure the dock connector.

Footstep xx

Catch the dock connector and remove it.

Footstep 21

The display assembly of your Milky way S6 Edge is now disassembled.

You tin can supplant it with a new one if needed.